• 产品特点
  • 技术规格

 单缸、四冲程、水冷、纯电起动发动机

 采用直气道设计、加大气门、减小气门夹角以提高进气流量,增加压缩比,优化燃烧室形状,燃烧更充分

 采用轻量化设计(活塞、活塞环),减少摩擦和振动,提高动力性能

 采用双级过滤润滑技术,优化油道,使用外置油管,滤清效果好,且维护方便

 采用内置平衡轴,配置消隙的副齿传动,保证整机振动小、平衡轴齿轮噪声小

 采用全铝镀镍气缸体技术,提高缸体耐磨、耐腐蚀性,降低缸体重量

 采用专用加强型曲轴、平衡轴、主副轴轴承,轴承寿命更高,可靠性好

 采用整体式嵌件,增强箱体平衡轴孔、曲轴孔、双头螺栓孔局部强度

 采用调整垫片取代调节螺钉方式来驱动气门,点面接触换成了线面接触,磨损更小,气门间隙变化小,减少气门间隙维护

 采用双张紧机构技术,传动平稳,音质柔和

 搭载滑动离合器,传递扭矩能力大,手柄力值小;离合器啮合、脱开平稳、迅速

 优化变速机构,换挡更顺畅、轻松

 

 Single cylinder, four stroke, water cooled, electric starting engine.

 Adopt straight air inlet design, increase the valve, reduce the valve angle to increase the intake flow rate, increase the compression ratio, optimize the shape of the combustion chamber, and combustion more fully.

 The lightweight design (piston, piston ring) reduces friction and vibration and improves power performance.

 The two-stage filtration lubrication technology is adopted to optimize the oil passage, and the external tubing is better filtration effect and easy maintenance.

 With built-in balance shaft, equipped with anti-backlash auxiliary gear transmission, to ensure the vibration of the whole machine, balance shaft gear noise is small.

 The all-aluminum nickel plating cylinder body technology is used to improve the wear resistance and corrosion resistance and reduce the weight of the cylinder body.

 Special reinforced crankshaft, balance shaft, main and counter shaft bearings, bearing life is higher, good reliability.

 Integral inserts to enhance the strength of the balance shaft hole, crankshaft hole, and double head bolt hole.

 The valve is driven by adjusting gasket instead of adjusting screw. The point contact is replaced by line contact. The wear is less, the valve clearance changes less, and the valve clearance maintenance is reduced.

 Double tensioning mechanism technology, smooth transmission, soft sound quality.

 Equipped with sliding clutch, large torque transmission capacity, small handle force value; The clutch engages and disengages smoothly and quickly.

 Optimize the transmission mechanism for smoother and easier shifting.

外特性曲线 WIDE OPEN THROTTLE CURVES

 

悬挂图 INSTALLATION DIMENSIONS

Copyright © 2014 loncinengine.com All Rights Reserved
电话:400 636 9980 地址:重庆市九龙坡区九龙工业园C区聚业路116号 邮箱:Engine_loncin@sina.com 传真:86 23 8669 3433